Stainless Steel Strips / Coils

Grades:
Our company supplies stainless steel strips of various grades in accordance with EN and ASTM/AISI standards. The typical grades are presented in the section "Materials"

Tolerances:
Normally thickness and width tolerances of regular stainless steel strips and coils are regulated by the standard DIN EN 9445-2
It is possible for our customers to order strips and coils with only plus or only minus thickness tolerance.
Our customers can also order strips with tighter width tolerances than defined by the standard (for instance as low as 0.01 mm), which is important for some high-tech applications.

Surface Finish and Mechanical Properties:
Normally, cold-rolled stainless steel strips have a 2B or 2R/BA finish.
The mechanical properties of regular stainless steel strips and coils normally follow the EN 10088-2 standard.

Edge of strips:

  • We supply stainless steel strips with following edges:
  • Normal slit edge
  • Very low burr (less than 5% of strip thickness)
  • Deburred edge
  • Rounded edge
  • Other custom edges

Dimensions:
Our thickness range for regular stainless steel strips and coils is from 0.3 mm to 3.0 mm.
Our minimum width is 3 mm. The maximum width is determined by our customers' requirements.
Typical widths for regular stainless steel coils are 1000 mm, 1219 mm, 1250 mm and 1500 mm.

Inner diameters of coils :
The typical inner diameters of our stainless steel strips are 300 mm, 406 mm, 508 mm.
We also supply strips with inner diameters of 200 mm, 250 mm or even non-standard diameters.
Regular coils are typically supplied with an inner diameter of 508 mm and 610 mm.

  • de
  • en

DMA Hamburg Inox & Alloys GmbH
Ferdinandstraße 25-27
20095 Hamburg
Telefon: 04105 69095 0
E-Mail: info@dma-hamburg.de
© DMA Hamburg
all rights reserved

site created and hosted by nordicweb